Addlnloop - Cisco MGX 8850 Command Reference Manual

addlnloop

addlnloop
Add Line Loop
Specifies a loopback state for a line on the current service module.
Note Before you can change the loopback type for an existing loopback, you must first delete the loopback
by executing dellnloop or just addlnloop with the No loopback mode.
Cards on Which This Command Runs
AXSM
AXSM Syntax
addlnloop <-ds3 | -sonet bay.line> <-lpb loopback type>
For AXSM cards, the keyword ds3 applies to both T3 and E3 line types.
Note
AXSM Syntax Description
-ds3
-sonet
bay.line
-lpb
Related Commands
dellnloop
Attributes
Log: log
Example
Adding a DS3 line in a loopback state.
MGX8850.1.11.AXSM.a > addlnloop -ds3 1.1 -lpb 2
Cisco MGX 8850 Routing Switch Command Reference
9-8
Specifies a DS3 line (E3 or T3) or a SONET line (OC-3c, OC-12c, OC-48c).
Identifies the bay (1 or 2) and the number of the line. The line number can be 1 to the
highest numbered line on the back card.
Specifies the loopback type for the line type. The entry for no loopback (1) removes
any existing loopback.
1 = No loopback
2 = Local loopback
3 = Remote loopback
State: active
Chapter 9
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Troubleshooting Commands