Dsppnsysaddr - Cisco MGX 8850 Command Reference Manual

dsppnsysaddr

dsppnsysaddr
Display PNNI Port System Addresses
The dsppnsysaddr command displays addresses in the system address table. The system address table
only contains static addresses.
Note This command does not belong to the RA module.
Cards on Which This Command Runs
PXM45
Syntax
dsppnsysaddr
[ ilmi | uni | static | host | all ]
Syntax Description
ilmi
uni
static
host
all
Display Contents
The ATM address, the address prefixes, and the peer group identifier share some default field values, as
shown in
The following parameters are displayed for each node.
ATM Address
(displayed but not
labeled)
Type
Port id
Cisco MGX 8850 Routing Switch Command Reference
6-100
— displays the PNNI system address table.
Display all of the ilmi addresses in the peer group.
Display all of the uni addresses in the peer group.
Display all of the static addresses in the peer group.
Display all of the host addresses in the peer group.
Display all of the addresses. This is the default.
Figure 6-2.
Display the PNNI node ATM address. This is a 20-byte, formatted hexadecimal
string. Like all PNNI addresses, identifiers, and prefixes, this value is portrayed
as a string of hexadecimal "nibbles." One or several pairs of nibbles entail each
parameter field.
Default: Figure 6-2
Display the type of address that you specified in the command line.
Range: ilmi, uni, static, host
The PNNI logical port identifier.
Range: 1–2147483648
Chapter 6 Logical Node, Port, and Signaling Commands
shows the factory-set default.
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001