Cisco MGX 8850 Command Reference Manual page 174

addpart
Example
Create a resource partition with the following parameters:
•
•
•
•
•
•
MGX8850.3.AXSM.a > addpart 4 4 2 100000 100000 100000 100000 10 110 100 2000 100 500
Check the configuration with dspparts and dsppart.
MGX8850.3.AXSM.a > dspparts
if
Num ID
-----------------------------------------------------------------------------
4
MGX8850.3.AXSM.a > dsppart 4 4
Interface Number
Partition Id
Controller Id
egr Guaranteed bw(.0001percent): 100000
egr Maximum bw(.0001percent)
ing Guaranteed bw(.0001percent): 100000
ing Maximum bw(.0001percent)
min vpi
max vpi
min vci
max vci
guaranteed connections
maximum connections
Cisco MGX 8850 Routing Switch Command Reference
3-14
Logical port 4 (already created by executing addport)
Partition number 4
Controller ID 2 (the reserved ID for PNNI)
10% of the bandwidth in the egress and ingress directions reserved for this partition
The range for VPIs is 10–110, the range for VCIs is 100–2000
Minimum guaranteed connections is 100, maximum number of connections is 500
part Ctlr egr egr
ID GuarBw MaxBw
(.0001%)(.0001%)(.0001%)(.0001%)
4 2 100000 100000
ingr ingr min max
GuarBw MaxBw vpi vpi
100000 100000 10 110
: 4
: 4 Number of SPVC: 0
: 2 Number of SPVP: 0
Number of SVC : 0
: 100000
: 100000
: 10
: 110
: 100
: 2000
: 100
: 500
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3 Equipment and Resource Provisioning
min max min max
vci vci conn conn
100 2000 100 500