Cisco MGX 8850 Command Reference Manual page 173

Chapter 3 Equipment and Resource Provisioning
ctrlr_id
egrminbw
egrmaxbw
ingminbw
ingmaxbw
minvpi
maxvpi
minvci
maxvci
minConns
maxConns
Related Commands
cnfpart, delpart, dspparts, dsppart
Attributes
Log: log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
A number in the range 1–3 that identifies a network controller. The numbers are
reserved, as follows:
1 = PAR (Portable AutoRoute)—currently not used
2 = PNNI
3 = LSC (Label Switch Controller, also known as MPLS for Multiprotocol Label
Switch Controller)—currently not used
A guaranteed percentage of egress bandwidth. Each unit of egrminbw is 0.000001 of
the total bandwidth on the port. (An egrMinBw of 1000000 = 100%.) This approach
provides a high level of granularity.
A maximum percentage of the bandwidth. Each unit of egrmaxbw is 0.000001 of the
total bandwidth available to the port. (An egrMaxBw of 1000000 = 100%.) The
resulting bandwidth must be at least 50 cps.
A guaranteed percentage of the ingress bandwidth. Each unit of ingminbw is 0.000001
of the total bandwidth available to the port. For example, an ingMinBw of
1000000 = 100%.
A maximum percentage of the ingress bandwidth. Each increment of ingmaxbw is
0.000001 of the total bandwidth on the port. For example, an ingMaxBw of
1000000 = 100%. Note that the maximum ingress bandwidth must be at least 50 cps.
Minimum VPI. For NNI, the range is 0–4095. For UNI, the range is 0–255.
Maximum VPI in the range 0–4095 for an NNI. For a UNI, the range is 0–255. The
maxvpi cannot be less than the minvpi.
Minimum VCI in the range 0–2000 (OC-48 only) or 32–65535.
Maximum VCI in the range 0–2000 (OC-48 only) or 32–65535.
A guaranteed number of connections. The range is between 0 and the maximum
number of connections in the port group. See dspcd for information on port groups.
A maximum number of connections. The range is between 10 and the maximum
number of connections in the port group. See dspcd port group information. The
value of maxConns cannot be less than the value of minConns.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
addpart
3-13