Cisco MGX 8850 Command Reference Manual page 703

Chapter 9 Troubleshooting Commands
Display Connection on the AXSM
On the AXSM, dspcon shows the following connection identifiers:
•
The provisioning parameters in the display show:
•
•
•
•
•
The traffic management parameters consist of:
•
These other fields also pertain to connection integrity:
•
•
•
The dspcon command requires a unique connection identifier. If you do not have the information to
identify a connection, execute dspcons. On the AXSM, dspcons identifies all the connections on the
AXSM. On the PXM45, dspcons identifies all the connections on the node. (See dspcons description).
and Egress directions.
Cards on Which This Command Runs
AXSM, PXM45
AXSM Syntax
dspcon
ifNum
<
vpi
<
vci
<
PXM45 Syntax
dspcon
portid
<
vpi
<
vci
<
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
NSAP address, logical port, VPI/VCI, status, and ownership of local and remote ends of the
connection. The display shows whether a particular endpoint is the master or slave.
Connection type of VPC or VCC.
Service type (for example, ABR).
A number indicating the controller. For example, 2 refers to PNNI. The addcontroller command
specifies the controller.
The administrative state is either up or down. This state results from addcon or dncon/upcon. Note
that, after you down a connection with at the connection master endpoint, the dspcon command
shows the connection as "down" when you execute it at the master endpoint and "failed" when you
execute it at the slave endpoint. (See also dncon description).
The operational state is either OK or failed. The operational state can apply to a connection
regardless of the administrative state.
Local and remote UPC parameters of PCR, MBS, CTD, CDVT, and so on. A –1 in a field means
that the parameter was not specified. The characters "N/A" indicate that the parameter does not
apply to the service type.
OAM connectivity check enable or disable.
Loopback test enable/disable and loopback type.
Round trip delay in microseconds. This field is non-zero only if you previously executed tstdelay.
>
>
>
>
>
>
Cisco MGX 8850 Routing Switch Command Reference
dspcon
9-85