Dspxbaralm - Cisco MGX 8850 Command Reference Manual

dspxbaralm

dspxbaralm
Display Crossbar Alarms—display severity of crossbar alarms.
The dspxbaralm command shows whether a crossbar alarm is minor, major, or critical. The display
shows status on both the active and standby PXM45.
Note This low-level command normally applies to software or hardware development and therefore is not
useful for troubleshooting at the network or node level. For troubleshooting at the switch level, use
dspndalms and dspswalms.
For fault isolation after you execute dspxbaralm, you can survey the possible errors (illustrated in the
example). The following is a top-down sequence of alarm-related commands:
1.
2.
3.
4.
Cards on Which This Command Runs
PXM45
Syntax
dspxbaralm
Syntax Description
This command takes no parameters.
Attributes
Log: no log
Related Commands
dspxbar, dspxbarerrcnt, dspxbarerrthresh, dspndalms, dspswalms
Cisco MGX 8850 Routing Switch Command Reference
9-134
dspndalms
dspswalms
dspxbaralm
dspxbarerrcnt
State: active
Chapter 9
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Troubleshooting Commands