Setipconndebug - Cisco MGX 8850 Command Reference Manual

setipconndebug

setipconndebug
Set IP Connection Debug
Specify a debug mode and whether to use a console for debugging IP connectivity. This command
requires SUPER_GP privilege. After you set the debug level, a status message states the current level.
Syntax
setipconndebug [-console | -noconsole] [debuglevel]
Syntax Description
-console | -no console
debuglevel
Attributes
Log: no log
Example
Set IP connection debug to console and specify a debug level of 20 for SVC call events.
node19.8.PXM.a > setipconndebug -console 20
Cisco MGX 8850 Routing Switch Command Reference
2-90
Configure where to run setipconndebig: console (ASCII) terminal or
elsewhere.
Specifies a debug level. To select one or all of the following levels, enter the
associated hexadecimal number and include the leading "0x" (see example):
• No Logging (0x0)
Task Errors (0x1)
•
• Task Debug (0x2)
• ATM Protocol (0x4)
• Task Startup (0x8)
Task Events (0x10)
•
SVC Call Events (0x20)
•
ATMARP Protocol (0x40)
•
Task Timers (0x80)
•
Interface Cache (0x100)
•
• Subtask Events (0x200)
• DISKDB Events (0x400)
RAMDB Events (0x800)
•
• TRAP Events (0x1000)
All Logging (0xffffffff)
•
State: active, standby, init
Chapter 2 Shelf Management Commands
Privilege: SERVICE_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001