Users - Cisco MGX 8850 Command Reference Manual

Chapter 2 Shelf Management Commands

users

Users—display the ID of each user logged into a card.
The users command shows the:
•
•
•
•
•
Note that users shows the current user sessions, whereas the dspusers command shows the names of all
the user accounts on the switch whether or not a corresponding user has logged in.
Cards on Which This Command Runs
PXM45, AXSM
Syntax
users
Syntax Description
This command takes no parameters.
Related Commands
dspusers, adduser, cnfuser, timeout
Attributes
Log: no log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Access method and port (telnet session to the PXM45, for example)
Current card slot
Idle time for the user session (can depend on the sesntimeout command)
User-name (the login name)
Point from which the user gained access (for example, an IP address in the case of a telnet session
or the word "console" if the user logged in through a local terminal at the console port)
State: active, standby Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
users
2-101