Cisco MGX 8850 Command Reference Manual page 709

Chapter 9 Troubleshooting Commands
Cards on Which This Command Runs
PXM45, AXSM
PXM45 Syntax
dspcons
[-port portid]
[-vpi starting-vpi]
[-vci starting vci]
[-state {fail|ais|abit|ok|down}]
[-owner {master|slave}]
PXM45 Syntax Description
port
-
vpi
-
vci
-
state
-
-owner
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The port identifier (portid) in the format that the network controller utilizes:
[shelf.]slot[:subslot].port[:subport]
Currently, the value for shelf is not necessary.
The VPI of the connection that you would like to serve as the starting
connection in the display.
The VPI of the connection that you would like to serve as the starting
connection in the display.
A specific connection state. The display shows only the connections with the
state you specify. Note that on the PXM45, you must spell out the entire state
keyword. The keywords for specifying a state are
failed—only failed connections
ais—connections with alarm indication signal (AIS) set
abit—connections on which an A-bit error has occurred
ok—connections with no problems
down—connections that are administratively down because a user has
executed dncon to down the connection
Specifies connections where the local endpoint is either master or slave.
Cisco MGX 8850 Routing Switch Command Reference
dspcons
9-91