dspserialif
dspserialif
Display Serial Interface
The dspserialif command displays the data rate on one of the serial interfaces on the PXM45-UI-S3 back
card. See cnfserialif for an explanation. (See the Cisco MGX 8850 Routing Switch Software
Configuration Guide for an explanation of the application of these physical ports.)
Cards on Which This Command Executes
PXM45
Syntax
dspserialif <port#>
Syntax Description
port#
Related Commands
addserialif, delserialif, cnfserialif
Attributes
Log: no log
Example
Display the console port speed.
Jupiter_Lower.7.PXM.a > dspserialif 2
SerialPortNum
SerialPortType
SerialPortSpeed : 19200
Cisco MGX 8850 Routing Switch Command Reference
2-66
Specifies the physical port:
•
1=maintenance port.
•
2=console port.
State: active
: 2
: console
Chapter 2
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Shelf Management Commands