Cnfapsln - Cisco MGX 8850 Command Reference Manual

Chapter 3 Equipment and Resource Provisioning

cnfapsln

Configure APS Line
Configures the APS parameters for a line (working line). Use the cnfapsln command after creating the
line using the addapsln command.
See the description for the addapsln command for a detailed explanation of Automatic Protection
Switching (APS).
Cards on Which This Command Runs
AXSM
Syntax
cnfapsln
-w <working line>
[-sf
[-sd SignalDegradeBER]
[-wtr Wait To Restore]
[-dr direction]
[-rv revertive]
Syntax Description
workingLine
SignalFaultBER
SignalDegradeBER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
SignalFaultBER ]
Slot number, bay number, and line number of the active line to configure, in
the format:
slot.bay.line
Example: -w 1.1.1
A number between 3 and 5 indicating the Signal Fault Bit Error Rate (BER),
in powers of ten:
• 3 = 10
4 = 10
•
5 = 10
•
Example: -sf 3
A power if 10 in the range 5–9 that indicates the Signal Degrade Bit Error
Rate (BER):
• 5 = 10
• 6 = 10
• 7 = 10
8 = 10
•
• 9 = 10
Example: -sd 5
-3
-4
-5
-5
-6
-7
-8
-9
Cisco MGX 8850 Routing Switch Command Reference
cnfapsln
3-23