Table of Contents
Advertisement
Chapter 4
AUSM Command Reference
addlnloop
Add Line Loop
Use the addlnloop command to loop the transmit and receive paths on a line for testing.
Syntax
addlnloop <line_num>
Syntax Description
line_num
Related Commands
dellnloop, dspln
Use the dspln command to display the loopback status of a line.
Tip
Attributes
Log: Yes
Example
Place line 8 on the AUSM card in loopback mode.
PXM1E_SJ.1.21.AUSMB8.a > addlnloop 8
PXM1E_SJ.1.21.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Use the dsplns command to display the available lines.
State: Active
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Service Group
addlnloop
4-17
Advertisement
Table of Contents
