Displaying A Resource Partition Configuration; Adding A Resource Partition; Table 3-3 Parameters For The Addrscprtn And Cnfrscprtn Commands - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Managing Resource Partitions
During normal operation, you will not need to add a resource partition. You can view the resource
partition configuration, make changes to it, or delete it. If you delete a resource partition, you will have
to create a new partition for that port before you can assign connections to the port.
The following sections describe how to view, add, modify, and delete resource partitions.

Displaying a Resource Partition Configuration

To display the resource partition configuration for a port, enter the dsprscprtn command as follows:
PXM1E_SJ.1.1.AUSMB8.a > dsprscprtn <port>
Replace the port parameter with the ATM port or IMA group number. For example:
PXM1E_SJ.1.1.AUSMB8.a > dsprscprtn 1
Port
---- ----- --------
1
PXM1E_SJ.1.1.AUSMB8.a >

Adding a Resource Partition

To add a resource partition to a port, enter the addrscprtn command as follows:
PXM1E_SJ.1.1.AUSMB8.a > addrscprtn <port_num> <cntrlr_type> <pct_bw_ingr> <pct_bw_egr>
<low_vpi> <high_vpi> <low_vci> <high_vci> <low_vpid> <high_vpid> <max_lcn> <cntrlr_id>
Table 3-3
Table 3-3
Parameter
port_num
cntrlr_type
pct_bw_ingr
pct_bw_egr
low_vpi
high_vpi
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
3-12
User NumOfLcn VPI
Low/High
--------
PNNI 1000 0 / 255 1
lists and describes the parameters for the addrscprtn command.
Parameters for the addrscprtn and cnfrscprtn Commands
Description
Port number to be partitioned. You must add a port to a line before you can define
a partition for a port. Use the dspports command to view the available ports.
Controller for this partition. Enter 2 as the PNNI controller is the only controller
type supported in this release.
• PAR = 1
PNNI = 2
•
• MPLS = 3
Ingress bandwidth percentage. Enter the percentage of the line bandwidth to be
used by this controller for ingress communications. Range is 1 to 100 percent.
Egress bandwidth percentage. Enter the percentage of the line bandwidth to be
used by this controller for egress communications. Range is 1 to 100 percent.
Enter the minimum VPI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 255.
Enter the maximum VPI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 255.
VPID VCI
Low/High Low/High
--------- ------------
/ 1000 0 / 65535
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Chapter 3 AUSM Card Management
IngrBW EgrBW CtrlrId
------ ----- -------
100 100 2