Avaya S8700 Maintenance Manual page 2183

SNI-BD (SNI Circuit Pack)
Table 8-579. TEST #759 Configuration Audit — Continued
Error Test
Code Result Description / Recommendation
2306 ABORT The SNI circuit pack is not responding to test requests sent by software.
1. Run the test led switch-node for the switch node where this board resides
2. If the LEDs on the other boards in the carrier light, but the LEDs on this
3. If none of the LEDs light for the boards in the same carrier as this board, fix
4. Follow the procedure described above, SNI Manual Loopback to determine
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
102 FAIL The SNI circuit pack cannot communicate with the equipped SNI in slot 2.
1. Perform the Fiber Fault Isolation Procedure described in Chapter 5. This
2. If the SNI being tested has SNI-PEER error type 1, replace the SNI being
3. If the SNI being tested has SNI-PEER error type 1, replace the SNI in slot
555-233-143
to verify whether the LEDs on the board light.
board do not light, run test 760 via test board UUCSS for the active SNC
in this carrier. Wait 5 minutes and then try step 1 one more time. If the
LEDs on this board still do not light, replace this board. Replacing an SNI
may be service interrupting. See
8-1429 for the procedure for replacing an SNI.
any problems associated with the connectivity of this carrier to the server.
a. Check list fiber-link to determine the fiber connections to this carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the associated repair procedures for
any EXP-INTF error entries associated with the controlling
IPSI-connected EPN.
d. Follow the associated repair procedures for any SYNC, SNI-BD,
SNC-BD, FIBER-LK, or SNI-PEER error entries.
whether the circuit pack or the fiber connection is faulty.
will resolve multiple SNI-PEER errors.
tested. Replacing an SNI may be service interrupting. See
Circuit Pack)'' on page 8-1429
view SNI-PEER errors, use the display errors command with category
PNC-PEER. Retry the command.
2. Replacing an SNI may be service interrupting. See
Circuit Pack)'' on page 8-1429
Retry the command.
''SNI-BD (SNI Circuit Pack)'' on page
for the procedure for replacing an SNI. To
''SNI-BD (SNI
for the procedure for replacing an SNI.
Continued on next page
Issue 1 May 2002
''SNI-BD (SNI
8-1461