Avaya S8700 Maintenance Manual page 2175

SNI-BD (SNI Circuit Pack)
Table 8-576. TEST #755 SNI Circuit Path Test — Continued
Error Test
Code Result Description / Recommendation
PASS The SNI passed the sni circuit path test.
0 NO No board was detected by the test.
BOARD
1. Check that board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNI should be reset
3. Run the test again. If it fails, the ID chip on board may be bad. Replace
555-233-143
instead of reseating the circuit pack. The reset board command should
almost never be used on an SNI. It may be necessary to use the reset
board command if the SNI circuit pack gets into a mode where it cannot
communicate with software. If an SNI with active errors and alarms is
reset, the errors and alarms may take a while to come back, therefore the
reset board command can mask real problems.
the board and retest.
Continued on next page
Issue 1 May 2002 8-1453