Avaya S8700 Maintenance Manual page 2186

Maintenance-Object Repair Procedures
Table 8-579. TEST #759 Configuration Audit — Continued
Error Test
Code Result Description / Recommendation
109 FAIL The SNI circuit pack cannot communicate with the equipped SNI in slot 9.
1. Perform the Fiber Fault Isolation Procedure described in Chapter 5. This
2. If the SNI being tested has SNI-PEER error type 1793, replace the SNI
3. If the SNI being tested has SNI-PEER error type 1793, replace the SNI in
112 FAIL The SNI circuit pack cannot communicate with the active SNC.
1. Check the error log for other SNI circuit packs in the same carrier with a
2. Replace this SNI. Replacing an SNI may be service interrupting. See
3. Replace the active SNC in the same switch node carrier. Replacing an
113 FAIL The SNI circuit pack cannot communicate with the equipped SNI in slot 13.
1. Perform the Fiber Fault Isolation Procedure described in Chapter 5. This
2. If the SNI being tested has SNI-PEER error type 2049, replace the SNI
3. If the SNI being tested has SNI-PEER error type 2049, replace the SNI in
8-1464 Issue 1 May 2002
will resolve multiple SNI-PEER errors.
being tested. Replacing an SNI may be service interrupting. See
(SNI Circuit Pack)'' on page 8-1429
To view SNI-PEER errors, use the display errors command with category
PNC-PEER. Retry the command.
slot 9. Replacing an SNI may be service interrupting. See
Circuit Pack)'' on page 8-1429
Retry the command.
257 SNI-BD error. Use display errors with category PNC to view SNI-BD
errors. If other SNI circuit packs in the same switch node carrier have error
257, then replace the active SNC in this switch node carrier. Replacing an
SNC may be service interrupting. See
Circuit Pack)'' on page 8-1384
other SNI circuit packs in the same carrier do not have SNI-BD error type
257 logged, proceed to step 2.
''SNI-BD (SNI Circuit Pack)'' on page 8-1429
replacing an SNI.
SNC may be service interrupting. See
Circuit Pack)'' on page 8-1384
will resolve multiple SNI-PEER errors.
being tested. Replacing an SNI may be service interrupting. See
(SNI Circuit Pack)'' on page 8-1429
To view SNI-PEER errors, use the display errors command with category
PNC-PEER. Retry the command.
slot 13. Replacing an SNI may be service interrupting. See
Circuit Pack)'' on page 8-1429
Retry the command.
for the procedure for replacing an SNI.
for the procedure for replacing an SNI.
''SNC-BD (Switch Node Clock
for the procedure for replacing an SNC. If
for the procedure for
''SNC-BD (Switch Node Clock
for the procedure for replacing an SNC.
for the procedure for replacing an SNI.
for the procedure for replacing an SNI.
Continued on next page
''SNI-BD
''SNI-BD (SNI
''SNI-BD
''SNI-BD (SNI
555-233-143