Removing And Installing Sealing Flange (Gearbox End) - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Insert counter-hold tool - 3067- into the hole -pos. B- of cylinder
block.
– Loosen and remove flywheel bolts.
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Renew bolts that are tightened with specified further tightening
♦
angle.
Flywheel with sender wheel can only be fitted in one position.
♦
– Insert counter-hold tool - 3067- in hole in cylinder block
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with -item A-.
respect to the correctness of information in this document. Copyright by SEAT S.A.
Specified torques
♦ ⇒ "2.1 Exploded view - cylinder block, gearbox end",
page 49
2.3 Removing and installing sealing flange
(gearbox end)
Special tools and workshop equipment required
♦ Open ring spanner - V.A.G 1332/11-
♦ Depth gauge - VAS 6082-
León 2013 ➤ , León ST 2013 ➤
2. Cylinder block, gearbox end
51