Removing And Installing Flywheel - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Sealing flange on gearbox side - Prescribed torque and tightening
sequence
– Tighten bolts in stages as follows:
stage Bolts
1. -1 ... 6-
2. -1 ... 6-
Installing intermediate plate
– Engage intermediate plate on sealing flange -top arrow- and
push onto dowel sleeves -bottom arrows-.
2.2

Removing and installing flywheel

Special tools and workshop equipment required
♦ Counter-hold tool - 3067-
Removing
• Gearbox removed
50
Rep. gr.13 - Crankshaft group
Tightening torque
Screw in by hand until they make con‐
tact
in diagonal sequence and in stages;
final torque 10 Nm.
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.