Removing And Installing Engine Support - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Fit vibration damper, oil threads of bolt for vibration damper
and screw it in to stop by hand.
– Tighten bolt -arrow- of the vibration damper, using the coun‐
terhold tool - T10475- to do so.
Remaining installation sequence carried out in reverse sequence;
note the following:
– Fit poly V-belt ⇒ page 38
Specified torques
♦ ⇒ "1.1 Exploded view - poly V-belt drive", page 35
1.5

Removing and installing engine support

Removing
– Disconnect battery ⇒ Electrical system; Rep. gr. 27 ; Battery;
Disconnecting and connecting battery .
– Move clear hoses at bracket -3-.
– Unscrew bolt -2-.
– Release clips -arrows- and remove upper toothed belt guard
-1-.
– Unscrew bolt -1-.
Note
Item -2- can be disregarded.
– Screw out bolt -1- and remove the retainer -2- for the catalytic
converter.
42
Rep. gr.13 - Crankshaft group
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.