Removing And Installing Tensioner For Poly V-Belt; Exploded View - Poly V-Belt Drive, Vehicles Without Air - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Turn tensioner anticlockwise -arrow- and remove locking pin -
T10060 A- .
– Release tensioner.
– Check that poly V-belt is properly seated.
– Start engine and check that poly V-belt runs properly.
1.3 Removing and installing tensioner for
poly V-belt
⇒ "1.3.1 Clamping fixture for V-belt: removing and installing, ve‐
hicles without air conditioner compressor", page 40
⇒ "1.3.2 Clamping fixture for V-belt: removing and installing, ve‐
hicles with air conditioner compressor", page 40
1.3.1 Clamping fixture for V-belt: removing
and installing, vehicles without air con‐
ditioner compressor
Removing
– Detach poly V-belt from tensioner
⇒ "1.2.1 Poly-V belt: Removing and installing, vehicles without
air conditioner compressor", page 38
– Remove bolts -arrows- and detach poly V-belt tensioner -1-.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Fit poly V-belt ⇒ page 38
Specified torques
♦ ⇒ "1.1.1 Exploded view - poly V-belt drive, vehicles without air
conditioner compressor", page 35
1.3.2 Clamping fixture for V-belt: removing
and installing, vehicles with air condi‐
tioner compressor
Removing
– Detach poly V-belt from tensioner
⇒ "1.2.2 Poly-V belt: Removing and installing, vehicles with air
conditioner compressor", page 39
40
Rep. gr.13 - Crankshaft group
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
.