León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
14 - Nut
❑ 30 Nm
15 - Clamp (front)
❑ Align exhaust system so it is free of stress before tightening clamp
❑ Installation position
❑ Tighten bolted connections evenly
Installation position of front clamp
– Fit clamp in position shown.
•
Angle -α- = approx. 20°.
•
Bolt connection facing towards right
•
Nuts facing upwards
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Installing catalytic converter - tightening torque and sequence
1.
– Fit catalytic converter to tur‐
bocharger, attach screw-type
clip -arrow- without tightening
2.
– Loosely screw in bolts -3, 5-
and bolts -1, 2, 4- by hand
3.
– Tighten screw-type clip
-arrow-
4th
– Tighten bolts and nuts in the
sequence -1 ... 5-.
2.2
Removing and installing catalytic con‐
verter
Note
The catalytic converter is removed together with the front exhaust
pipe.
Removing
Note
Attach cable ties in all the same places when installing.
264
Rep. gr.26 - Exhaust system
⇒ page 264
respect to the correctness of information in this document. Copyright by SEAT S.A.
•
It should still be
possible to move
catalytic converter
and bracket.
15 Nm
20 Nm
⇒ page 261