Align Exhaust System To Be Free Of Stress - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unscrew bolts -1- and -2-.
– Unscrew bolt -3-, and remove rear silencer -4-.
Installation
Installation is carried out in the reverse order; noting the following
in the process:
Note
Make sure to obtain the -dimension a- between the marks
-arrows-.
– Align exhaust system without tension
⇒ "1.4 Align exhaust system to be free of stress", page 261
Specified torques
♦ ⇒ "1.1 Exploded view - silencers", page 253
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
♦ ⇒ "2.1 Assembly overview - emission control", page 263
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody
trim; Assembly overview - underbody trim panels
1.4

Align exhaust system to be free of stress

⇒ "1.4.1 Align exhaust system to be free of stress", page 261
⇒ "1.4.2 Aligning tailpipes", page 262
1.4.1 Align exhaust system to be free of stress
Work sequence
• The exhaust system must be aligned when cold.
• Specified torques
⇒ "2.1 Assembly overview - emission control", page 263
Note
-Arrow- points in direction of travel
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
.
1. Exhaust pipes/silencers
261