Disconnecting Exhaust Pipes/Silencers - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Aligning mounting »C«
– Pre-tighten bolt.
– Arrange hanger over the long hole bore
– Align holes -arrows- of mounting -C- centrally using blunt side
of commercially available 8 mm drill bit.
– Then tighten to specified torque.
Installation position of rear clamp
– Fit clamp in position shown.
• Angle -α- = approx. 20°.
• Bolt connections face to rear.
• Nuts facing upwards
1.2

Disconnecting exhaust pipes/silencers

⇒ "1.2.1 Separating exhaust pipe / silencer, Leon SC 5 door mod‐
el", page 257
⇒ "1.2.2 Disconnecting exhaust pipes/silencers, Leon ST",
page 258
1.2.1 Separating exhaust pipe / silencer, Leon
SC 5 door model
♦ The connecting pipe can be cut through at the cutting point in
order to renew the centre and rear silencers separately.
♦ Cutting location is marked by an indentation on circumference
of exhaust pipe.
Special tools and workshop equipment required
♦ Chain-type pipe cutter - VAS 6254-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
1. Exhaust pipes/silencers
257