Fitting The Bulb Holder - Seat Toledo 2015 Owner's Manual

Fig. 160 Remove the lamp holder
The rear lid must be open to change the
bulbs.
You can access the bulb holder for the inner
tail lights through the inside of the rear lid.
Check which of the bulbs is defective.
–
Open the cover to access the lights, turning
–
it by hand in the direction indicated by the
arrows.
Access the lights by disconnecting the con-
–
›››
nector Fig. 160  and unscrewing
1
172
Advice
›››
the bulb holder Fig. 160 . Take care not
to lose the bulb holder retaining screw.
›››
Change the bulbs page 172.
–
Changing bulbs
Fig. 161 Position of the bulbs in the bulb
holder
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
›››
bulbs table on page 172.
Lightly press the defective bulb into the
–
bulb holder, then turn it anti-clockwise and
remove it.
Fit the new bulb, pressing it into the bulb
–
holder and turn it clockwise as far as it will
go.
Use a cloth to remove any fingerprints from
–
the glass part of the bulb.
Check that the new bulb works properly.
–
›››
Re-install the bulb holder page
–
Screw in the bulb holder.
–
Position of the bulbs
›››
Fig. 161 Bulb function
Reverse light
A
Side lights
B
Fog lights
C
Note
One of the two sides may not be fitted with a
fog light, depending on the country and type
of driving. In this case, the hole for the light
is covered.

Fitting the bulb holder

Position the bulb holder on the tail light
–
and align it so that it is securely seated.
Screw in the bulb holder using the corre-
–
sponding screw.
Make sure the connector is correctly in
–
place.
Close the inner trim cover.
–
172.
P21W
R5W LL
P21W