Supercharger Air System; Assembly Overview - Charge Air System - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
2

Supercharger air system:

⇒ "2.1 Assembly overview - charge air system", page 197
⇒ "2.2 Removing and installing the air intake pipe", page 199
⇒ "2.3 Removing and installing charge pressure sender G31 / in‐
take air temperature sender G42 ", page 200
⇒ "2.4 Removing and installing charge air cooler", page 200
⇒ "2.5 Checking charge air system for leaks", page 202
2.1

Assembly overview - charge air system

Note
Check all air hoses and pipes for firm seating and leaks before carrying out tests or repairs.
♦
Observe rules for cleanliness
♦
1 - Coolant hose
2 - Bolt
❑ Thread-forming
❑ Fit and screw in bolt by
hand so that it is
screwed into old thread.
Then tighten the screw
with the stated torque
❑ 15 Nm
3 - Coolant hose
4 - Coolant hose
5 - Intercooler system
❑ Removing and installing
⇒ page 200
❑ If renewed, refill system
with fresh coolant
6 - Sealing lip
7 - Seal
❑ renew
8 - Intake manifold
Removing and installing
⇒ page 229
9 - Bolt
❑ Tightening torque and
sequence ⇒ page 228
10 - O-ring
❑ renew
11 - Intake manifold sender -
GX9-
❑ comprising:
Intake air temperature sender 2 - G299-
Intake manifold pressure sender - G71-
⇒ page 4 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
.
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Supercharger air system:
197