Removing And Installing Radiator Cowl; Removing And Installing Radiator Fans - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
4.5

Removing and installing radiator cowl

CAUTION
Risk of injury to hands caused radiator fan which may start au‐
tomatically at any time.
– Do not grasp into the radiator fan when disconnecting con‐
nector.
Removing
– Loosen the hose clip -2-, remove the air intake hose.
– Remove bolts -arrows-.
– Unlatch the air duct in the lock carrier and remove
-in the direction of the arrow-.
– Unplug electrical connector -1- for radiator fan (push retainer
to the rear -arrow A- and press down release catch).
– Press locking tabs on left and right sides of radiator cowl
-arrow B- and at the same time lift radiator cowl off radiator.
– For this purpose, turn the fan guard upwards by approximately
45° on one side.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Electrical connections and routing ⇒ Current flow diagrams,
Electrical fault finding and Fitting locations.
Specified torques
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 225
4.6

Removing and installing radiator fans

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
CAUTION
respect to the correctness of information in this document. Copyright by SEAT S.A.
Risk of injury to hands caused radiator fan which may start au‐
tomatically at any time.
– Do not grasp into the radiator fan when disconnecting con‐
nector.
Removing
Note
Attach cable ties in all the same places when installing.
– Remove radiator cowl ⇒ page 187 .
León 2013 ➤ , León ST 2013 ➤
4. Radiator/radiator fans
187