Removing And Installing Coolant Temperature Sender - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Detach thermostat -2- from coolant pump -1-.
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Renew gasket.
– Moisten gasket with coolant.
– Fit thermostat housing onto coolant pump.
• Centring pins on thermostat must be fitted in guides -arrows-
on coolant pump.
– Tighten bolts for thermostat housing
– Fit the coolant pump
– Fill up with coolant ⇒ page 150
Specified torques
♦ ⇒ Fig. ""Thermostat housing to coolant pump - tightening tor‐
que and sequence"" , page 159
2.8 Removing and installing coolant temper‐
ature sender
⇒ "2.8.1 Removing and installing coolant temperature sender G62
", page 171
⇒ "2.8.2 Removing and installing coolant temperature sender at
radiator outlet G83 ", page 172
2.8.1 Removing and installing coolant temper‐
ature sender - G62-
Removing
• Engine cold.
– To relieve residual pressure in cooling system, open filler cap
-arrow- on coolant expansion tank briefly and then close cap
again (it should click into place).
– Unplug the electrical connector.
Note
Place a cloth underneath to catch escaping coolant.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 159
⇒ page 162 .
.
León 2013 ➤ , León ST 2013 ➤
.
2. Coolant pump/thermostat assembly
171