Removing And Installing Toothed Belt Pulley For Coolant Pump; Removing And Installing Electric Coolant Pump - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
2.5 Removing and installing toothed belt
pulley for coolant pump
Special tools and workshop equipment required
♦ counter-hold tool - T10172- with adapter -T10172/2-
Removing
– Remove coolant pump
– Loosen bolt -1- using counter-hold tool - T10172- with adapt‐
ers -T10172/2- .
– Unscrew bolt and remove toothed belt pulley -2-.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Fitting toothed belt pulley:
• The grooves -1- and -2- in the camshaft are arranged asym‐
metrically.
• The recesses -arrows- in toothed belt pulley are also arranged
in a asymmetrical way.
– Fit toothed belt pulley onto camshaft so that the grooves of the
camshaft are fully centred within the recesses of the toothed
belt pulley.
– Fit the coolant pump
Specified torques
♦ ⇒ "2.1 Exploded view - coolant pump and thermostat",
page 157
2.6 Removing and installing electric coolant
pump
Special tools and workshop equipment required
166
Rep. gr.19 - Cooling
⇒ page 162 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 162 .