Removing And Installing The Oil Separator - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
3.2 Removing and installing the oil separa‐
tor
Special tools and workshop equipment required
♦ Commercially available sealant remover
♦ Sealant ⇒ Electronic parts catalogue (ETKA)
Removing
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
– Unscrew bolts -arrow- and push charge air cooling pump -
V188- to one side.
– Disconnect crankcase breather hose -3-.
– Release fasteners -2- -arrow- on cover -1- for oil separator and
detach cover.
– Slacken and remove bolts in the sequence: -9 ... 1-.
– Carefully release oil separator from bonded joint.
Installation
Installation is carried out in the reverse order. Please note the
following:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Note
Danger of soiling lubrication system!
♦
Cover exposed parts of the engine.
♦
– Thoroughly clean sealing surfaces on cylinder block and on oil
separator using commercially available sealant remover.
– Clean surfaces; they must be free of oil and grease.
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
3. Crankcase breather system
141