Engine Oil; Removing And Installing Sump - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Securing threaded connection for oil filter
• If threaded connection -2- from top section of sump -1- has
loosened, secure it as described below.
Only carry out procedure with both nuts -3 and 4-
• 2 x hex nuts - 068 115 723- ⇒ Electronic parts catalogue
– Screw nuts -3- and -4- onto threaded connection -2- and coun‐
terlock them.
– Tighten threaded connection -2- by tightening nut -3-.
– Loosen and unscrew both nuts, taking care not to loosen
threaded connection.
Specified torques
Threaded connection
-2-
1.2

Engine oil

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Oil capacities
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ Maintenance ; Booklet 501
Engine oil specifications
⇒ Maintenance ; Booklet 501
Changing the engine oil: ⇒ Maintenance ; Booklet 501 "Engine
oil: drain".
Note
After adding oil, always check correct oil level on oil dipstick.
♦
⇒ page 129
The oil level must not be above the max. mark - danger of
♦
damaging catalytic converter. Marks
1.3

Removing and installing sump

Special tools and workshop equipment required
♦ Oil filter tool - 3417-
130
Rep. gr.17 - Lubrication
Tightening torque
50 Nm
⇒ page 129 ,