Removing And Installing Camshaft Housing - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Fit cylinder head gasket -1-.
♦ Note position of centralising pins in cylinder block -arrows-.
♦ Note the installation position of cylinder head cover. Part No.
should be legible from inlet side.
– If crankshaft has been rotated in the meantime: set No. 1 cyl‐
inder piston to top dead centre. Turn crankshaft back slightly.
– Fit cylinder head.
– Insert and cylinder head bolts and tighten hand-tight.
– Tighten cylinder head cover bolts
Note
Cylinder head bolts do not have to be torqued down again later
after repair work.
Remaining installation sequence carried out in reverse sequence;
note the following:
– Install camshaft housing
– Remove intake manifold
– Change engine oil ⇒ Maintenance ; Booklet 501 .
– Fill cooling system with fresh coolant
Specified torques
♦ ⇒ Fig. ""Engine support - Tightening torque and sequence"" ,
page 26
♦ ⇒ "1.1 Exploded view - cylinder head", page 69
♦ ⇒ "1.1 Exploded view - turbocharger", page 189
♦ ⇒ "4.1 Intake manifold - exploded view", page 228
♦ ⇒ Fig. ""Installing catalytic converter - tightening torque and
sequence"" , page 264
♦ ⇒ Running gear, axles, steering; Rep. gr. 40 ; Drive shaft;
Assembly overview: drive shaft
1.4 Removing and installing camshaft hous‐
ing
Removing
– Remove the coolant pump
– Remove air cleaner housing
– Removing ignition coils.
– Detach toothed belt from camshafts
– Remove high-pressure pipe -3-
76
Rep. gr.15 - Cylinder head, valve gear
⇒ page 70 .
⇒ page 76 .
⇒ page 229
⇒ page 150
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 162 .
⇒ page 226 .
⇒ page 269
⇒ page 89
⇒ page 248 .
.
.