Removing And Installing Cylinder Head - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
❑ Inserted into cylinder head.
Note
Versions with or without oil
♦
strainers are used depending on
build date.
If no strainer was installed at the
♦
factory, a strainer is instead inte‐
grated in camshaft control valve
1 - N205- .
Damage may result if the strainer
♦
is installed in both locations!
16 - Oil seal
❑ For inlet camshaft
❑ Replace
⇒ "3.5.1 Removing and installing camshaft oil seal for inlet camshaft, belt pulley end", page 111
17 - Oil seal
❑ For exhaust camshaft (pulley end)
❑ Replace ⇒ "3.5.2 Removing and installing exhaust camshaft oil seal, pulley end", page 113
18 - Sealing cap
Camshaft housing - tightening torque and sequence
Note
Renew bolts that are tightened with specified further tightening
angle.
– Tighten bolts in stages in the sequence shown:
stage Bolts
1. -1 ... 15-
2. -1 ... 15-
1.3

Removing and installing cylinder head

Special tools and workshop equipment required
♦ Socket and key - 3410-
72
Rep. gr.15 - Cylinder head, valve gear
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Tightening torque/angle specification
10 Nm
turn 180° further