Crankshaft Oil Seal- Pulley Side: Replace - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Fit vibration damper, oil threads of bolt for vibration damper
and screw it in to stop by hand.
– Tighten bolt -arrow- of the vibration damper, using the coun‐
terhold tool - T10475- to do so.
– Remove tension device for the Poly V-belt
⇒ "1.3 Removing and installing tensioner for poly V-belt", page
40
– Check adjustment of assembly mountings (engine/gearbox
mountings) ⇒ page 32
Specified torques
♦ ⇒ "2.1 Exploded view - assembly mountings", page 25
♦ ⇒ "1.1 Exploded view - poly V-belt drive", page 35
♦ ⇒ "2.1 Exploded view - toothed belt cover", page 82
♦ ⇒ "1.1.2 Exploded view - poly V-belt drive, vehicles with air
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
conditioner compressor", page 37
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ ⇒ "2.1 Assembly overview - charge air system", page 197
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 225
♦ ⇒ "2.1 Assembly overview - emission control", page 263
♦ ⇒ Electrical system; Rep. gr. 27 ; Alternator; Exploded view
- alternator
♦ ⇒ Electrical system; Rep. gr. 27 ; Battery; Assembly overview
- battery
♦ ⇒ General body repairs, exterior; Rep. gr. 50 ; Noise insula‐
tion; Assembly overview - noise insulation
1.6

Crankshaft oil seal- pulley side: replace

Special tools and workshop equipment required
♦ Assembly tool - T10485-
♦ Puller hooks - T20143-
46
Rep. gr.13 - Crankshaft group
.