Installing an Injector Module
Thermo Scientific
ATTENTION Chaque boîtier doit toujours être occupé par les deux modules. Si le GC est
configuré avec un seul module d'injecteur / détecteur, un module factice doit être inséré à
la place du module injecteur / détecteur manquant.
Les modules d'injecteur et de détecteur sont fournis avec un bouchon. Avant d'installer la
colonne, retirez le bouchon.
To install the injector and detector modules, see the following procedures:
•
Installing an Injector Module
•
Installing a Detector Module
To install an injector module
1. Remove the dummy module from the position where the injector module will be
installed.
a. Open the module flap cover.
b. Using a T20 Torxhead screwdriver, unscrew the two captive fixing screws.
c. Keeping the dummy module flap cover open, lift up the module from its seat in the
injector housing. Place the dummy module on a clean surface.
d. Remove the gas block plug from the gas connection by unscrewing its fixing screw
using a T20 Torxhead screwdriver.
Figure 2.
Injector Gas Block Plug
Installing the Injector and Detector Modules
Gas Block Plug on Injector Seat
O-ring
Gas Connection Without Gas Block Plug
TRACE 1600/1610 Hardware Manual
1
Installation
5