Thermo Scientific TRACE 1600 Hardware Manual page 603

Thermo Scientific
a. Carefully guide the gas tubing block on the manifold located into the auxiliary gas
module. See Figure 595
module is installed on the left.
Figure 595. Installation on the Right Side
Figure 596. Installation on the Left Side
b. Align the fixing screws of the gas tubing block with the corresponding holes on the
manifold.
c. Use the T20 Torxhead screwdriver to tighten the two fixing screws without
overtightening.
5. Connect the gas tubes of interest to the Auxiliary Gas Interface.
a. Guide the three gas tubes up to reach the Auxiliary Gas interface.
if the module is installed on the right, or
10
Adding Systems
Adding an Auxiliary Gas System
Figure 596
TRACE 1600/1610 Hardware Manual
if the
571