Installing The Module - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

3.5.2 Installing the Module

After the USB software for the module has been installed (→ page 43), install and
configure the module in Chromeleon:
1. Start the Chromeleon Server Monitor and the Chromeleon server if they are not yet
running (→ page 43).
2. Start the Server Configuration program in Chromeleon.
Click Start on the taskbar. Point to Programs (or All Programs, depending on the
operating system), point to Chromeleon, and then click Server Configuration.
3. If necessary, click the plus sign next to the server name to display the items
underneath.
4. Select the timebase to which the module will be assigned, or create a new timebase (on
the Edit menu, click Add Timebase).
5. Open the Add device to timebase dialog box. To do so, click Add Device on the Edit
menu or right-click the timebase and click Add Device on the menu.
6. On the Manufacturers list, click Dionex HPLC: UltiMate 3000 and on the Devices
list, click the module you want to add, for example, NCS-3500RS Nano/Cap System.
7. The configuration pages for the module are opened. On each configuration page,
verify that the settings are correct and select additional settings if needed. For a
description of the pages, see section 3.5.3.1 (→ page 46).
8. On the File menu, click Save Installation and then close the Server Configuration
program.
Operating Instructions
UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Page 45