Thermo Scientific
Figure 468. Housing Cover Removal
a. Using a T20 Torxhead screwdriver, unscrew and remove the left or right housing
cover screws.
b. Remove the covers from the housing.
11. Install the module into the housing.
a. Loosen the two hexagonal screws under the module. See
Figure 469. Module Installation (1)
b. Place the module into the left or right housing until the hexagonal screws couple the
slots on the floor of the GC. See
Figure
Figure
470.
TRACE 1600/1610 Hardware Manual
9
Adding Modules
Adding a NPD Detector Module
Left Cover
Screws
Right Cover
Screws
Left/Right Housing Covers
469.
Hexagonal Screws
473