Thermo Scientific
a. Loosen the two hexagonal screws under the module. See
Figure 591. Module Installation (1)
b. Carefully place the module into the left or right housing.
c. Push the module until the hexagonal screws couple with the slots on the floor of the
GC. See
Figure
592.
Figure 592. Module Installation (2)
d. Finger-tighten the hexagonal screws slightly, or use a 10-mm wrench.
10
Adding Systems
Adding an Auxiliary Gas System
Figure
591.
Hexagonal Screws
Slots
TRACE 1600/1610 Hardware Manual
569