Installing A Ftir Make-Up Module - Thermo Scientific TRACE 1600 Hardware Manual

8
Installing Optional Kits

Installing a FTIR Make-up Module

Installing a FTIR Make-up Module
420 TRACE 1600/1610 Hardware Manual
This section provides instructions for installing the FTIR Make-up module on your
TRACE 1600/1610 for the connection with the Thermo Scientific Nicolet iS50 FT-IR
.
Spectrometer According to the configuration of your TRACE 1600/1610, a dummy module
is present into the free site where the detector module is not installed. See
Figure 406. Add a Front/Back Detector Module
Dummy Front Detector Module
CAUTION The gas connection for a dummy module is blocked by a plug.
ATTENTION Le raccordement au gaz d'un module factice est obturé par un bouchon.
The FTIR Make-up module must be installed into the detectors housing, and supplied
through the line of the front/back carrier gas.
IMPORTANT If the front/back carrier gas is not already used by an injector module, you
must install the front/back carrier gas inlet, and connect the carrier gas line as described in
the section "Making the Gas Supply Plumbing Connections"
The module is equipped with an ON/OFF needle valve for the regulation of the gas flow.
• Open the needle valve manually turning the knob counter-clockwise.
• Close the needle valve manually turning the knob clockwise.
Perform the regulation of the gas flow using a little flat head screwdriver.
Figure 406.
Dummy Back Detector Module
on page 8.
Thermo Scientific