Thermo Scientific TRACE 1600 Hardware Manual page 588

10
Adding Systems
Adding the PTV and PTVBKF Cryo System
556 TRACE 1600/1610 Hardware Manual
c. Connect the other end of the cryo supply tube to the coolant container using the
appropriate nuts and ferrules. Use a 7/16-in. wrench for tightening the fittings.
12. Connect the cryo valve to the Aux Temperature/Cryo Module.
a. Connect the cryo solenoid valve to the 2-pin connector marked Cryo Valves - Front
Inlet or Cryo Valves-Back Inlet using the cable provided. See
Figure 576. Cryo Valves: Oven
b. Using the cable provided, connect the 15-pin female connector marked GC Bus on
the module to a Bus interface on the back of the GC.
c. Plug the power cable to the AC Input connector on the front of the module and to
the wall outlet. The LED marked On lights after the GC is powered on.
Note For further details regarding the installation of the Aux Temperature/Cryo
module, see the section
page 478.
d. Using the cable provided, connect the 15-pin female connector marked GC Bus on
the module to a Bus interface on the back of the GC.
13. Mount the left side panel proceeding in reverse order which the left side panel was
removed.
14. Open the gas supplies.
15. If other external modules are present, plug the power cable to the AC Input connector of
each external module, and to the wall outlet.
16. Power on the GC.
a. Plug the power cable to the AC Input connector on the back of the GC, and to the
wall outlet.
b. Flip up the power switch (breaker), located at the back of the instrument, to the
position I.
17. Configure and enable the cryogenic system through the user interface of your GC, or
through the CDS in use. Refer to the TRACE 1600/1610 User Guide.
a. Configuration and enabling through the touch screen.
i. In the main menu select the Configuration icon, the Configuration menu
appears.
"Adding an Aux Temperature/Cryo Module"
Figure 576.
on
Thermo Scientific