Installing The Auxiliary Gas Interface On The Oven For Hrms - Thermo Scientific TRACE 1600 Hardware Manual

Installing the Auxiliary Gas Interface on the Oven for HRMS

Thermo Scientific
Figure 586. Perform the Duct for the Auxiliary Gas Interface (4)
4. Jump to the section "Installing and Connecting the Auxiliary Gas Module"
 To make the duct into the oven for HRMS
1. Remove the left/right side panel.
a. Open the front door of the GC.
b. Use a T20 Torxhead screwdriver to loosen the left/right side panel screw from the
interior front panel. Save the screw because it will be reused later.
c. Slide the panel towards the back of the instrument up to the stop.
d. Remove the panel pulling it outward being aware that the ground wire is attached to
the panel.
2. Prepare the duct for the installation of the auxiliary gas interface.
10
Adding Systems
Adding an Auxiliary Gas System
on
TRACE 1600/1610 Hardware Manual
page 568.
565