Making The Lan Setup - Thermo Scientific TRACE 1600 Hardware Manual

1
Installation
Setting the LAN Communication

Making the LAN Setup

42 TRACE 1600/1610 Hardware Manual
 To set the LAN communication
1. Using the LAN RED patch, connect a desktop or laptop PC directly to the RJ45
connector marked LAN/Ethernet on the Electronic Module of the GC. See
Figure 46. GC/PC LAN Connection
LAN Standard RED Patch
2. Power on the GC by placing the power switch in the On (up) position marked I.
3. Power on the PC.
4. Start the GC and AS Service Tools program to begin the installation on the PC. Follow
the instructions step by step to complete the installation.
Note Use the GC and AS Service Tools program to set the LAN Communication
parameters, and updating the Firmware version on the GC.
Updating the Firmware version on the GC must be carried out by a Thermo Fisher
Scientific authorized technical personnel.
Visit http://www.gc-gcms-customersupport.com/WebPage/Share/Default.aspx
contact your local Thermo Fisher Scientific office or affiliate GC-GC/MS Customer
Support
5. Run the GC and AS Service Tools program. Click the icon on your desktop or select
Start > Program > GC and AS Service Tool.
6. The system starts scanning the equipment powered on and connected to the LAN.
During this stage, the three buttons on the top of the page are disabled. See
Computer
Figure 46.
to
Figure 47.
Thermo Scientific