10
Adding Systems
Adding the Oven Cryo System
538
TRACE 1600/1610 Hardware Manual
Figure 549. Module Installation (1)
b. Place the module into the left or right housing until the hexagonal screws couple the
slots on the floor of the GC. See
Figure 550. Module Installation (2)
c. Finger-tighten the hexagonal screws slightly, or use a 10-mm wrench.
Note Always keep the hexagonal screws in their place. This allows you an easier
removal of the auxiliary module when necessary.
The result of the installation is shown in
Figure
550.
Figure
551.
Hexagonal Screws
Slots
Thermo Scientific