Adding A Gsv Injector Module - Thermo Scientific TRACE 1600 Hardware Manual

Adding a GSV Injector Module

Thermo Scientific
Table 17. Column Insertion Depth For SSL, SSLBKF, PTV, and PTVBKF Injectors
SSL
5 mm (splitless)
10 mm (split)
18. Close the front door of the GC.
19. If present, move the autosampler towards the module to restore the original alignment.
This section provides instructions for adding a front/back Gas Sampling Valve injector
module. According to the configuration of your TRACE 1600/1610, a dummy module is
present into the free site where the injector module is not installed. See
Figure 455. Location of Injector Modules on the TRACE 1600/1610 GC
Empty Front Injector Module
CAUTION The gas connection for a dummy module is blocked by a plug.
ATTENTION Le raccordement au gaz d'un module factice est obturé par un bouchon.
SSLBKF PTV
5 mm (splitless) 30 mm
10 mm (split) As far as possible into
the bottom when the
PTV is used as an
On-Column injector.
Dummy Back Detector Module
9
Adding Modules
Adding a GSV Injector Module
PTVBKF
30 mm
Figure 455.
TRACE 1600/1610 Hardware Manual 459