Thermo Scientific TRACE 1600 Hardware Manual page 546

9
Adding Modules
Adding a Generic Detector Interface
514 TRACE 1600/1610 Hardware Manual
Figure 520. GDI Module Installation (2)
c. Finger-tighten the hexagonal screws slightly, or use a 10-mm wrench.
Note Always keep the hexagonal screws in their place. This allows you an easier
removal of the GDI electrical interface when necessary.
IMPORTANT If an GDI mechanical module will be installed on the TRACE 1600/1610
GC, continue the procedure from the
installed on the TRACE 1600 Auxiliary Oven, jump to the section
Interface to the TRACE 1600 Auxiliary Oven"
3. Connect the 26-pin connector of the detector cable coming from the GDI electrical
interface to the backplane board in the electronic compartment.
a. On the backplane board disconnect the flat cable from the connector marked J13
DET.FRONT if the GDI mechanical module is installed in the Front site, or from
the connector marked J5 DET.REAR if the GDI mechanical module is installed in
the Back site. See
step 3. If an GDI mechanical module will be
on
Figure 521.
"Connecting a GDI
page 517.
Slots
Thermo Scientific