Thermo Scientific TRACE 1600 Hardware Manual page 387

Thermo Scientific
ATTENTION Attention à ne pas casser le liner en verre lors de son extraction. Des
éclats de verre pourraient tomber dans la partie inférieure de la chambre de
vaporisation.
b. Holding the HS/SPME liner with tweezers place the new liner seal over the liner.
c. Insert the liner into the injector and push it gently towards the bottom of the injector.
12. Install the purge & trap adapter on the top of the injector. See
Figure 334. Purge & Trap Adapter (1)
Septum Cap
Ring Nut
Septum
Purge & Trap Adapter
a. Avoid touching the septum with your fingers. Insert a new septum into the septum
holder cavity of the purge & trap adapter using tweezers. See
Figure 335. Purge & Trap Adapter (2)
Installing the Purge & Trap Adapter Kit on the SSL/SSLBKF Injector
TRACE 1600/1610 Hardware Manual
8
Installing Optional Kits
Figure 334.
Figure 335.
355