Setting The Lan Communication - Thermo Scientific TRACE 1600 Hardware Manual

Setting the LAN Communication

Thermo Scientific
This section provides instructions for setting the desired IP and the LAN communication port
for the TRACE 1600/1610. See
Before making the LAN setup, please read the following note.
Note The TRACE 1600/1610 allows LAN (Local Area Network) capabilities by the
presence of an RJ45 connector on the Electronic Module, and two LEDs for LAN
activity.
• IP Address —The GC is shipped with a factory IP address, which may not match the
LAN needs of the sites where the instrument will be installed. To change the default
values, contact your LAN administrator and ask for the IP address to be assigned, the
netmask, and eventually the port.
– The IP address is a 3 digits x 4 fields number given by the network administrator
- e.g. 192.168.127.10.
– The netmask is a 3 digits x 4 fields number given by the network administrator -
e.g. 255.255.255.0.
– The port number is 2551 and cannot be changed.
• Reset Button — To reset the LAN parameters (IP address, communication port, and
so on) to the default values, insert a small screwdriver into the hole, then push the
reset button for at least five seconds.
• Network Cables — Two network cables are included in the standard outfit:
– a reversed RED patch for the computer to TRACE 1600/1610 direct connection.
This is used for the initial setup operation and when the instrument is not
connected in remote mode.
– a standard GREY patch for the TRACE 1600/1610 to local area network
connection.
"Making the LAN Setup"
1
Setting the LAN Communication
on page 42.
TRACE 1600/1610 Hardware Manual
Installation
41