Adding a PDD Module
Getting Started
Thermo Scientific
This section provides instructions for adding a front/back PDD detector module. According
to the configuration of your TRACE 1600/1610, a dummy module is present into the free
site where the detector module is not installed. See
Figure 491. Location of Detector Modules on the TRACE 1600/1610 GC
Dummy Front Detector Module
CAUTION The gas connection for a dummy module is blocked by a plug.
ATTENTION Le raccordement au gaz d'un module factice est obturé par un bouchon.
To properly installing and connecting the PDD module see sequentially the following
sections:
•
"Installing a PDD Module"
•
"Plumbing the Gas Lines"
•
"Installing and Purging the Gas Regulator"
•
"Installing and Purging the Helium Purifier"
•
"Connecting the Discharge Gas Supply"
•
"Connecting the High Voltage and Pulses Cables"
•
"Installing the Capillary Column"
Figure
on
page 494
on
page 498
on
page 499
on
on
page 500
on
on
page 505
9
Adding Modules
Adding a PDD Module
491.
Dummy Back Detector Module
page 499
page 500
TRACE 1600/1610 Hardware Manual
493