Assembling The Gdi Electrical Interface - Thermo Scientific TRACE 1600 Hardware Manual

Assembling the GDI Electrical Interface

Thermo Scientific
Note Pay attention to the positioning of the ground wire plug, so it can be
reconnected in the same way it was removed.
If not already done, you must connect the detector cable and its cable grommet into the GDI
electrical interface. See Figure
Figure 511. GDI Electrical Interface Back View
 To assemble the GDI electrical interface
1. Unscrew the fixing screws of the GDI electrical interface using a T10 torxhead
screwdriver, and remove the top cover. See
Figure 512. Assemble GDI Electrical Interface (1)
2. On the board inside the control module look for the 26-pin male connector marked J4.
See Figure 513.
511.
Figure 512.
9
Adding Modules
Adding a Generic Detector Interface
Duct for Detector Cable
Detector Cable
TRACE 1600/1610 Hardware Manual 509