Adding A Ssl, Sslbkf, Ptv, Or Ptvbkf Injector Module - Thermo Scientific TRACE 1600 Hardware Manual

9
Adding Modules

Adding a SSL, SSLBKF, PTV, or PTVBKF Injector Module

Adding a SSL, SSLBKF, PTV, or PTVBKF Injector Module
456 TRACE 1600/1610 Hardware Manual
This section provides instructions for adding a front/back SSL, SSLBKF, PTV, or PTVBKF
injector module. According to the configuration of your TRACE 1600/1610, a dummy
module is present into the free site where the injector module is not installed.
See Figure 453.
Figure 453. Location of Injector Modules on the TRACE 1600/1610 GC
Empty Front Injector Module
CAUTION The gas connection for a dummy module is blocked by a plug.
ATTENTION Le raccordement au gaz d'un module factice est obturé par un bouchon.
 To add an SSL, SSLBKF, PTV, or PTVBKF injector module
1. Put the GC in standby condition.
2. Cool the oven, injector, and detector to room temperature.
Note By pressing the Maintenance button, the GC cool down is automatically
carried out.
3. Close the gas supplies.
4. Power off the GC.
a. Push down the power switch (breaker), located at the back of the instrument, to the
position O.
Dummy Back Detector Module
Thermo Scientific